How To Apply Tint To Rear Car Window

How to Install Beginner Level Rear Glass Tint!

Rear windows can exist quite a challenge to tint. Likewise the concerns of rear brake lights, rear speakers with surrounding interior padding and window embedded demister wires, rear windows are generally always curved to a contour that makes cleanly installing a unmarried slice of tint incommunicable unless it is rut-shrunk earlier installation. Hence, unless yous already accept some confidence in car tinting, we recommend installing your rear tint using the easy-install strips that practice non crave oestrus-shrinking.

This tutorial describes the procedure for installing the like shooting fish in a barrel-install strips, and does not include the heat shrinking process.

Rear Glass Cleaning

Give the inside and outside of the glass surface a thorough clean, however please be cautious of the demister strips! Do non be tempted to apply a razor over your rear windows, a single suspension in your demister lines will cause the rear demister to stop working! Advisedly remove any stickers that are affixed to the inside surface, careful use of a hair dryer may help to remove stubborn stickers without tearing. A towel placed over the rear speakers and interior padding will assistance to prevent any h2o harm.

Removal of Glass Peripheral Parts

We recommend that you lot disassemble whatsoever interior items such every bit high mount brake lights or interior padding that could interfere with your tint installation. Please use your own discretion hither. Every bit a general dominion, if it seems like it might get in the way when y'all are installing your tint, information technology probably volition. Best to brand the installation process as easy as possible past removing whatever obstructions earlier proceeding.

Prep the Film for Adhesion

Spray a generous amount of your sideslip solution in your spray canteen onto the cleaned glass surface. Place your tint onto the exterior rear window surface with the transparent plastic sheet facing outwards.

Please note that when y'all carve up the tint from the transparent sheet, unless your fingers are wet, permanent fingerprints can be left on the mucilage surface of the tint.

Try to continue your fingers moist when treatment tint!

Please be careful not allow the tint float freely when peeling back the transparent layer, kinks in the tint need to be avoided as much every bit possible.

Pare dorsum the transparent layer until you are left with about 5 to 10cm of unpeeled sheet on one side.

Give the exposed tint a expert spray with the tint solution.

Re-lay the transparent sheet back over onto the tint and begin to roll it dorsum upwardly advisedly, starting at the end that has yet to be peeled abroad, as can be seen in the adjacent diagram.

Installing Your Rear Window Tint

If possible, begin with some other quick spray and squeegee of the install area, it can never be too clean! Later your final clean, give the beginning install section of window a coating of slip solution.

With your roll of tint in both hands, separate the two layers, allowing one hand to lay the tint confronting the window surface while the other mitt unpeels the transparent layer away from the roll.

One time you have a 20cm or and so laid in identify, yous should exist able to pull away the remainder of the transparent layer without too much difficulty.

Position the tint and ensure that the tint looks fifty-fifty on the glass and that the black outside edges (frit & dot matrix) are covered on both sides.

Once your first strip of tint is positioned, spray the exterior of the tint with your slip solution and proceed to fix the tint to your glass in the same fashion explained for door windows (starting from the middle and pushing outwards to the edges, stop with microfibre or paper towel over the edges with your duster).

Repeat the whole procedure from step 3 for the 2nd piece of tint.

* When laying the 2nd piece, please overlap on the 1st slice by about 1.5mm across the acme border. This volition assist adhesion and allow the seam to blend in well with the demister lines.

Repeat the whole procedure from step iii for the third slice of tint in the same mode equally the 2nd.

Begin reassembly of whatever removed interior components such as restriction lights.

Congratulations, yous accept at present installed your new rear tint!